There are currently no product reviews.
1" COUPLING CHAIN SPROCKET connects to the bottom of the Table Shaft and to the other Coupling Chain Sprocket that is mounted to the Table...
Relay Switch (contactor) used on printed circuit board for the Power Column up and down on FG5000 and FG10000 Flywheel Grinders. 3 of these are...
The FG5000 and FG10000 both come with approximately 22 inches of this drain tubing. Buy it by the foot here, so to replace your drain tube you...
2 inch grinding wheel spacer. Precision made to prevent wheel vibration.
3/16” T Handle Wrench
Table Shaft Sprocket Coupler.
OEM replacement proximity sensor located under the depth of cut setting wheel on Flywheel Grinders equiped with the Auto-Grind Feature.
The small DC motor used in the Van Norman FG Flywheel Grinders that have the optional Auto-Grind Feature. This motor RARELY goes bad so be sure your...
The larger pulley without a clutch on it for the Auto-Grind feature on an FG5000 or FG10000 Flywheel Grinder.
Replacement belt for the Auto-Grind optional feather on FG5000 and FG10000 Flywheel Grinders
The larger o'ring that fits into the Bear Cap located between the Table Motor Gearbox and the under side of the table casting of all Van...
- 1. Coolant Pump for FG5000 and FG10000
- 2. Flexible Coolant Hose
- 3. Heavy Duty STOP button / switch...
- 4. OEM Flywheel Grinder Control Panel...
- 5. FSH Cap Screw .437-14 x 2.50ƒ?
- 6. Heavy Duty Coolant Pump On / Off...
- 7. Heavy Duty START button / switch...
- 8. Arbor Nut Wrench
- 9. OEM Flywheel Grinder Control Panel...
There currently are 29 guests online.