Permatex (#64000) High Heat Sleeve Retainer/Sealant

High Strength Sleeve Retainer is a one component, solventless, fast curing, anaerobic adhesive/sealant.

• Secures slip and press fit assemblies
• Restores fit to worn or out-of-tolerance assemblies
• Prevents surface corrosion
• Adds up to 3,000 PSI holding power
• Suggested Applications: Cylinder sleeves, valve guides, valve seats, bearings and bushings, woodruff keys, liner assemblies

This is a slow setting press fit locking sealant that can withstand very high temperatures once cured. The slow setting gives the operator plenty of time to get any positioning dialed in before the product locks it into place.

Used with our Paccar MX-13 Kit and replacement Stainless Steel Sleeve assemblies to seal and secure the new sleeves in place. The sleeves have serrations in the bottom nose that give the sealant some more to “bite” onto.

Excerpt from the Technical Data Sheet

PRODUCT BENEFITS

• No mixing • No curing outside of joint • No on-torque adjustments needed • Restores fit to worn assemblies • Prevents fretting and corrosion • Allows the use of slip fit or press fit • For use on assemblies with gaps up to 0.007” diametral

TYPICAL APPLICATIONS

• Cylinder sleeves • Valve seats • Bearings and bushings • Woodruff keys • Liner assemblies • Valve guides

DIRECTIONS FOR USE

1. Remove any grease or oil by using Permatex Brake & Parts Cleaner.
2. For slip fitted assemblies, apply adhesive around the leading edge of the collar and use a rotating motion during assembly.
3. For press fits, adhesive should be applied thoroughly to both bond surfaces and assembled at high press-on rates.
4. For shrink fitted assemblies, the adhesive should be coated onto the pin; the collar should then be heated to create sufficient clearance for free assembly.
5. For faster cure rates, use Permatex Surface Prep on both surfaces. (optional “activator”)
6. Parts should not be disturbed until sufficient handling strength is achieved.
7. Any material that is on the outside of the assembly will not cure. Wipe off with a dry cloth.

Cure Speed

• Hardens in 4 hours (faster when activator is used)

• Full cure in 24 hours

For Cleanup

1. Residual liquid films outside the joints are readily soluble in Permatex Brake & Parts Cleaner.
2. Cured product can be removed with a combination of soaking in Permatex Gasket Remover and mechanical abrasion such as a wire brush.